Supporting jaw components for compatible air or hydraulic collet chuck systems.
Air / Hydraulic Collet Chuck Jaws
KORRETTO air / hydraulic collet chuck jaws are replacement or matching jaw components used with compatible collet chuck systems. This page covers the jaws as supporting parts, not a complete collet chuck assembly. Selection should confirm chuck model, jaw interface, mounting pattern, clamping diameter, workpiece profile and actuation type.
Product Overview
Collet chuck jaws are used when the collet chuck system requires matching or replacement jaw components. They must be selected according to the chuck model and jaw interface. Using a similar-looking jaw without confirming the interface may lead to poor clamping, misalignment or unsafe operation.
This page should remain separate from complete air / hydraulic collet chuck pages.
Key Features
| Feature | Description |
|---|---|
| Supporting jaw component | Used with compatible air or hydraulic collet chuck systems. |
| Model-specific fit | Jaw interface and mounting pattern must match the chuck. |
| Workpiece-contact function | Jaw profile affects clamping contact and stability. |
| Replacement or matching use | Used for maintenance, setup change or workpiece-specific clamping. |
| Not a complete chuck page | This page covers jaws only, not the full chuck assembly. |
Typical Applications
- Replacement collet chuck jaws
- Workpiece-specific jaw setup
- Air or hydraulic collet chuck maintenance
- Chuck jaw matching
- Clamping surface adaptation
Technical Data and Dimensions
Use the drawing and parameter table to check jaw dimensions, mounting pattern, interface type, compatible chuck model and workpiece-contact range.
| Model | ΦA | ΦB | C | D | E | F | Custom Profile Hole Available | Extended Taper for Laser Front End |
|---|---|---|---|---|---|---|---|---|
| C-25 | 45 | 47.5 | 18 | 7 | 4.5 | M5 | Customizable | Customizable |
| C-40 | 65 | 67.5 | 26 | 9 | 6 | M6 | Customizable | Customizable |
| C-70 | 105 | 107.5 | 26 | 9 | 6 | M6 | Customizable | Customizable |
| C-120 | 140 | 143 | 29 | 9 | 6 | M6 | Customizable | Customizable |
FAQ
Are these complete collet chucks?
No. This page covers collet chuck jaws as supporting components for compatible air or hydraulic collet chuck systems.
How should I select the correct jaws?
Confirm the chuck model, jaw interface, mounting hole pattern, workpiece diameter and clamping surface before selection.
Can these jaws be used on any collet chuck?
No. They must match the specific chuck model and interface.
What information is needed for selection?
Provide the chuck model, jaw drawing if available, workpiece drawing, clamping diameter, mounting pattern and actuation type.
Can the jaw profile be customized?
In many cases the contact area can be matched to the workpiece, but the interface and base dimensions must remain compatible with the chuck.